Alpha Micro Components   | M2M Solutions for 2G/3G/4G, GNSS positioning, Bluetooth, Wi-Fi, sub 1GHz RF, serial-Ethernet, USB, antennas and card connectors.
Home > USB IC's & Cables > USB Cables

FTDI USB 2.0 Hi Speed to MPSSE (wire-ended) cable, 0.5m long - C232HM


Available Stock: 15
FTDI USB 2.0 Hi Speed to MPSSE (wire-ended) cable, 0.5m long - C232HM

Our Price: £23.00
Price Excludes VAT

 

C232HM

The USB 2.0 Hi-Speed to MPSSE cable contains a small internal electronic circuit board, utilising the FTDI FT232H, which is encapsulated into the USB connector end of the cable, this handles all the USB signalling and protocols. The cable provides a fast, simple way to connect devices with 3.3 Volt digitalinterfaces to USB.

The integrated FT232H device incorporates a command processor called the Multi-Protocol Synchronous Serial Engine (MPSSE). The purpose of the MPSSE command processor is to communicate with devices which use synchronous protocols (such as JTAG, SPI or I2C) in an efficient manner.

The cable is terminated by ten individual wires with single pole connectors which can be interfaced to a male header. Cable signals are compliant with CMOS logic at 3.3 volts.

 

C232HM-DDHSL-0 USB to MPSSE cable with +3.3V digital level signals. Maximum data rate 30Mbps. Single pole, receptacle x 10. 0.5m long.
C232HM-EDHSL-0 USB to MPSSE cable with +5V digital level signals. Maximum data rate 30Mbps. Single pole, receptacle x 10. 0.5m long.